Ganter Swivel Clamp Connector Joints, Plastic 286.9-B30-B30-T-2-SW

In the initial position, the clamping bore axes of the swivel clamp connector joints GN 286.9 are in line with each other and can be swiveled by ±90°. They hold typical construction tubes with full surface contact over the entire cross-section of the bore.At the screw locations z1, the socket cap screws reduce the bore cross-section for clamping. Adapter bushings GN 290 can be used to reduce the bore cross-sections to smaller diameters.The screw location z2 serves for fixing the joint axis, which can be adjusted continuously or in 10° steps, depending on the type.For clamping without tools, the socket cap screws can be replaced by the adjustable hand levers GN 911.9 listed in the table as accessory.