Ganter Swivel Clamp Connector Joints, Plastic 282.9-B30-40-T-2-GR

In the initial position, the clamping bore axis of the swivel clamp connector joints GN 282.9 is perpendicular to the flange surface and can be swiveled by ±90°. It holds typical construction tubes with full surface contact over the entire cross-section of the bore.At the screw location z1, the socket cap screw reduces the bore cross-section for clamping. Adapter bushings GN 290 can be used to reduce the bore cross-sections to smaller diameters.The screw location z2 serves for fixing the joint axis, which can be adjusted continuously or in 10° steps, depending on the type.For clamping without tools, the socket cap screws can be replaced by the adjustable hand levers GN 911.9 listed in the table as accessories.